Avery Dennison ADTP1 - Setting the Print Position; Setting the Supply Position

Classification: Avery Dennison – Public Setting Supply Options 2-7
Setting the Print Position
This function adjusts the image’s position on the supply in the feed direction. Adjust the
print position if the print is too close to the top or bottom of the supply, or overtypes the
pre-printed area. The adjustments are in dots where one dot equals 0.0049 inch.
Changing this setting only affects new formats sent to the printer. Any formats previously
saved into flash memory are not affected.
Select To

Decrease the setting. Moves the print down.

Increase the setting. Moves the print up.
Press 1 to toggle the amount (1, 10, or 100).
Setting the Supply Position
This function adjusts the position of the supply relative to the index marks in the feed
direction. Adjust the supply position to compensate for supply variation. The
adjustments are in dots where one dot equals 0.0049 inch.
Adjust the supply position only on initial printer setup. For format adjustments, change
the print position. This option takes effect when you print the next label or tag. Changing
supply position may also affect print position.
Select To

Decrease the setting. Moves the print down.

Increase the setting. Moves the print up.
Press 1 to toggle the amount (1, 10, or 100).