Classification: Avery Dennison – Public Setting RFID Options 8-11
Setting the Encode Zone
This option only appears in the Advanced Setup menu. The encode zone is only used in
non-stop encode mode.
The encode zone is the area where the antenna and inlay communicate with each other
during programming as the inlay moves over the antenna. It is the length in dots of the
programming zone (area). The range is 50 to 2000. The default is 200.
The encode zone should not exceed the pitch of the label. If the encode zone is too
large, adjacency issues may occur. See “What is Pitch
” for more information.
Use the RFID Printer Setup Utility to determine the encode zone then enter the value at
the printer.
Select To
Decrease the setting.
Increase the setting.
Press 1 to toggle the amount (1, 10, or 100).
Antenna
To Next Page
Loading...
