Avery Dennison ADTP1 - Setting Defaults

Classification: Avery Dennison – Public Setting Defaults 6-1
SETTING DEFAULTS
This chapter explains how to select the printer’s prompt language; monetary sign,
secondary sign, decimal places, slashed zero, power-up mode, prompt set, imaging
errors, ignore configuration packets, error retry, adjust the image length, set the sleep
delay, set the LCD contrast, ignore format numbers, and use a temporary graphics buffer.
This chapter also explains how to format flash, check the available flash memory, and
pack flash memory.
You can set your printer configurations to fit your daily operation, using either the offline
menus or the online configuration option. After an option is selected in the online
configuration or offline Setup Menu, the option is saved when the printer is turned off.
The monetary formatting options are in the table below.
Option
Choices
Default
Language
English, Français, Deutsch, Español-ES, ニホンゴ,
Português, Italiano, Svenska, Español-MX, Dansk,
Nederlands, Polski, Türkçe, 简体中文, Français-CA
English
Monetary sign None, $ Dollar, £ Pound, ¥ Yen, Deutsche Mark, F
Franc, P Peseta, L. Lira, Kr Krona, Markka, Shilling,
Rs Rupee, Ruble/Rubel, Won, Baht, ¥ Yuan, € Euro
$ Dollar
Secondary Sign No/Yes No
Decimal Places 0/1/2/3 2
Slashed Zero No/Yes No
Powerup Mode
Online/Offline
Online
Numeric Format
Default, Arabic-Indic, Eastern Arabic
Default
Flash Storage
Disabled/Enabled
Disabled
No Image Error Disable/Enable Disable
Ignore Config Disable/Enable Disable
Ignore BchCtl Disable/Enable Disable
Error Retry Disable/Enable Enable
Adjust Length
-30 to 30
0
Sleep Delay
0 to 240
60
LCD Contrast 1 to 9 3
Ignore Fmt #s Disable/Enable Disable
Temp G. Buffer Disable/Enable Disable
6