4-4 System Administrator’s Guide Classification: Avery Dennison - Public
Factory Defaults
If you reset the Ethernet/Wireless module to factory defaults, the following values are
restored. Some settings may stay the same, depending on your network
configuration.
Description Default
MAC Address This value is hard-coded and does not change
IP Address *
Subnet Mask 255.255.000.000
IP Gateway *
Signal Strength 0
SSID <none>
Wireless Mode Infrastructure
Roam Threshold 6
Transmit Rate 1
Channel 1
Boot Method DHCP
Boot Tries 5
TCP/IP Enabled
TCP Port 9100
LPD Disabled
Name PXR_xxxxxx (xxxxxx = last six digits of the MAC address.)
Encryption Mode Disabled
Authentication Type Open System
Authentication
Protocol
PAP
Regulatory Domain United States
* May keep previous values based on network configuration.
To Next Page
Loading...
