4-2 System Administrator’s Guide Classification: Avery Dennison - Public
Entering the IP Address
The IP (Internet Protocol) address is a unique identifier for a device on a network. It
consists of four 3-digit numeric fields, separated by periods. The printer has different IP
addresses for wired vs. wireless communication.
If using the optional keyboard, enter the IP address you need using the numeric keys and
press ENTER.
Select To
IP Address Change the printer’s IP address.
Press or to highlight the position to change. Press CHANGE until
you see the number you need. Press SET to save the setting or press
CANCEL to exit without saving.
If you enter a series of digits greater than 255 for any segment of the IP address and
press SET, the printer does not save the setting. Correct the setting, then press SET.
Entering the Subnet Mask
IP networks are divided using subnet masks. The subnet mask address determines
where the IP address belongs in the network. It consists of four 3-digit numeric fields.
If using the optional keyboard, enter the subnet mask you need using the numeric keys
and press ENTER.
Select To
Subnet Mask Change the printer’s subnet mask.
Press or to highlight the position to change. Press CHANGE until
you see the number you need. Press SET to save the setting or press
CANCEL to exit without saving.
If you enter a series of digits greater than 255 for any segment of the IP address and
press SET, the printer does not save the setting. Correct the setting, then press SET.
Entering the IP Gateway
The IP gateway (or router) allows connections (communications) between different
subnets on a network. It consists of four 3-digit numeric fields.
If using the optional keyboard, enter the IP gateway you need using the numeric keys and
press ENTER.
Select To
IP Gateway Change the printer’s IP gateway.
Press or to highlight the position to change. Press CHANGE until
you see the number you need. Press SET to save the setting or press
CANCEL to exit without saving.
If you enter a series of digits greater than 255 for any segment of the IP address and
press SET, the printer does not save the setting. Correct the setting, then press SET.
To Next Page
Loading...
