2-12 System Administrator’s Guide Classification: Avery Dennison - Public
Setting the Maximum Calibration Length
When using supply longer than 17.0 inches (3451 dots; 17 inches x 203 dots per inch =
3451 dots), set the maximum calibration length value to properly calibrate your supply.
The maximum calibration length is 34.0 inches (6902 dots).
Dots = Inches x 203
Dots = Metric (1/10 mm) x .799
Metric (1/10 mm) = inches x 254.
Determine the maximum calibration length. Measure the supply according to the supply
type:
Die cut supplies Measure from the leading edge of one label to the leading edge of
the next label accounting for the die cut gap. Enter this value in
dots.
Black mark supplies Measure from the top of one black mark to the top of the next
black mark. Enter this value in dots.
The leading edge is the edge of the label that exits the printer first; regardless of how the
format is designed on the label.
Select To
Decrease the setting. Shortens the maximum calibration length.
Increase the setting. Increases the maximum calibration length.
Press 1 to toggle the amount (1, 10, or 100).
18.0 inches
3654 dots
18.0 inches
3654 dots
E
E
To Next Page
Loading...
