11-4 System Administrator’s Guide Classification: Avery Dennison - Public
Using the Network Console Packet
If you cannot connect the printer to your network using MonarchNet2 (or similar
networking tool), try using a wired connection to configure the network printer. If that
does not work, send console commands to the printer instead. The network console
packet is written in MPCL and accepted through the printer’s serial port.
Syntax
{N,number,action,device,"name" |
C,"con_comds" | }
N1. N Network Console Packet.
N2. number Number from 0 to 999 to identify the network console
packet. 1 is the default.
N3. action Action. Enter A to add a network console packet.
N4. device Storage device. Enter T to pass the packet through the
printer and store the packet in the wireless module.
N5. “name” Packet name, 0 to 8 characters, enclose within quotation
marks. “” is the default.
C1. C Append data.
C2. “con_comds” Console commands. Must be enclosed within quotation
marks. “” is the default. Each command must be on a
separate line. The maximum number of characters per
command is 100. Refer to the complete list of console
commands in the ADTP1 MonarchNet2 Operating
Instructions for more information.
The maximum number of commands per packet is twenty
five (25).
IP Address Example
{N,1,A,T,"protocol" |
Names the packet protocol
C,"set ip me static" |
Sets method to obtain IP address as static
C,"set ip bot 5" |
Sets boot retries to 5
C,"set ip add 192.0.0.192" | Sets IP address to 192.0.0.192
C,"set ip sub 255.255.0.0" | Sets Subnet Mask to 255.255.0.0
C,"set ip ro 192.1.1.192" | Sets IP Gateway to 192.1.1.192
C,"init" |
Saves the settings and initializes the printer
C,"exit" | }
Exits console mode
To Next Page
Loading...
