Classification: Avery Dennison – Public Troubleshooting 11-3
10. From the Wireless Tab, set the SSID, Regulatory Domain, Roam Hysteresis, Mode,
Encryption Mode, Authentication Type, etc. Click Save Changes.
11. From the Protocols Tab, Click Save Changes. Any changes made on this screen or
other screens do not take effect until you click Save/Reboot. This process takes a
few minutes.
12. The MonarchNet2 screen should refresh and show the new printer’s name with a
wired connection.
13. Disconnect the Ethernet cable.
14. Turn off the printer. Wait two seconds, then turn on the
printer. You may need to cycle the printer’s power more than
once before a wireless connection is established.
15. Once an IP Address appears, Web back into the printer. Type
access for the password and click Submit. To verify the connection, click Virtual
Panel Display, and press Feed. The printer should feed a label.
To Next Page
Loading...
