10
1PLEASE NOTE
1.2 SAFETY INSTRUCTIONS
ALS
20x
256
1.2.2 Operational safety of the unit
Proper usage
The label dispenser described here is designed for
dispensing and applying pre-printed self-adhesive
labels to products or packages.
The label material that is used must be punched and in
roll shape. Punched means that the labels adhere
individually, separated by punchings, on a carrier
material. The labels must only adhere strongly enough
so that they will come loose when the material is
deflected over a sharp edge.
Usually, the label dispenser is integrated into a
superordinate system, e.g. a packaging system, by a
system integrator. The labels are typically attached to
products, which are moved by by an automatic
conveyor.
Any other type of or more extensive application will be
considered non-intended use.Avery Dennison shall
assume no liability for damage resulting from non-
intended use of the machine.
The system integrator must install the machine with
suitable equipment to protect operating personnel from
danger; for example, the danger of the hands or fingers
being crushed by reaching in between the product and
the dispensing edge.
WARNING!
Improper usage of the unit can cause
accidents, property damage and production
downtime!
Only use the unit in accordance with the
instructions specified in this manual.
Do not operate the unit without the
required safeguards.
Only configure the unit in accordance
with this manual and with the required
care.
Only use original accessories.
Do not make any modifications or
alterations to the unit.
Repairs to the device may only be
performed by authorised specialists who
are aware of the risks involved.
To Next Page
Loading...
