Avery Dennison ALS 256 - Threading the label roll at the dispensing edge

43
3BEFORE OPERATION
3.2 INSERTING LABEL MATERIAL
ALS
20x
256
GB
Threading the label roll at the dispensing
edge
Fixed [41] (standard) and pivotable L-Shape dispen-
sing edges:

Unroll around 1 m of label strip and remove the
labels from it.
 Pass the backing paper around the first deflection
roller [41A] and through the slot in the sensor [41B].
 Feed the backing paper under the pressure roller
[41C] to the dispensing plate [41D].
 Feed the backing paper around the dispensing plate
to the second deflection roller [41E].
Spring loaded [42] and pneumatic [43] L-Shape dispen-
sing edges:
 Additionally pass the backing paper between the
two slim deflection rollers at the joint [42A] [43A].
[43] Path of the label strip at the pneumatic dispensing edge (option).
[41] Path of the label strip at the dispensing edge.
A 1st deflection roller
B Label sensor
C Pressure roller
D Dispensing plate
E 2nd deflection roller
[42] Path of the label strip at the spring loaded dispensing edge
(option).
C
A
B
D
E
A
A
A
A