31
2PRODUCT DESCRIPTION
2.3 OPERATING MODES
ALS
20x
256
2.3.2 Configuration mode
The machine is in dispensing mode.
Switching to configuration mode:
Press the button twice.
– Display:
Press the button.
– Display:
– LABEL SETUP is the name of the first menu that is
currently active.
– In configuration mode, the button assignments are
as shown below the buttons.
Function of the double-arrow button
To dispense individual labels:
Press the button briefly (less than two
seconds).
– Dispensing speed: As specified in the configuration;
‘Speed Adaption’ is not active.
To automatically calibrate the label length:
Hold down the button for a while (longer than
two seconds).
Menus
In configuration mode, you have access to several
menus providing a fixed sequence of functions that can
be carried out.
You can set the unit so that some of the menus are not
shown.
Figure [26] shows the button functions for switching
between the individual menus and for leaving them.
OFFLINE
LABEL SETUP
[26 Menu selection and button functions in configuration mode.
A Button for triggering a dispensing procedure and for
starting the measurement of lengths.
B Explanation of buttons in configuration mode
C Menus
ON
STATUS
+
+
–
–
OFFLINE
LABEL SETUP
MACHINE SETUP
INTERFACE PARA
SIGNAL INTERFACE
SERVICE/DIAGNOS.
SERVICE DATA
To Next Page
Loading...
