Avery Dennison ALS 256 - List of error messages

60
6OPERATIONAL FAILURES
6.1 STATUS MESSAGES
ALS
20x
256
GB
6.1.3 List of error messages
Status Status text Cause Action to take
5000 Bus device – Device at I
2
C Bus cannot be
contacted.
– In most cases, this message appears
as the first in a series of two or three
messages which narrow down the
error more precisely.

Delete the message by pressing the
-key.
 Switch the machine off, wait 30
seconds and switch it back on.
 If the error message appears
repeatedly, call in a servicing
technician.
5001 No gap found – Material end, if no outer diameter
(OD) control is activated.
– The maximum limit for missing labels
was exceeded (LABEL SETUP > Miss.
label tol.).
– The machine is not correctly set for
the type of label (MACHINE SETUP >
Label sens. type).
– Label length is not correctly set
(LABEL SETUP > Label pitch).
– Photoelectric label sensor is dirty.
– Photoelectric label sensor is
incorrectly positioned.
– Photoelectric label sensor is not
connected correctly.
– Photoelectric label sensor is
defective.
– Rotary encoder is not adjusted
correctly.
 Check the points listed above and
correct if necessary.
 Press the key to confirm the
error message.
5002 Material end – Material end (if the internal OD-
control is activated).
 Insert new label roll.
5030
5031
MotorProtectFeed
MotorProtectRew.
– (ALS 256) Dust filter liner exhausted.
This leads to overheating the
machine.
– (ALS 20X) Voltage selection switch
set faulty.
– There are some more possible
causes, which require a qualified
service technician to cure.
 Renew the dust filter liner. Let the
machine cool down
 Check setting of the voltage
selectioin switch.
 Switch the machine off, wait 30
seconds and switch it back on.
 If none of the above listed actions is
successful, search for technical
assistance.
5071 Material end unw – Occurs during operation with
activated internal OD control.
– The message appears, if the material
roll diameter has reached the critical
value (setable by MACHINE SETUP >
Materialend err).
 Replenish the material roll .
[68] List of error messages