28
2PRODUCT DESCRIPTION
2.2 OPTIONS
ALS
20x
256
Capacitive label sensor
Optional sensor, required for processing transparent
labels [23]. The sensor is mounted to the rods of the
dispensing edge holder.
Printer
– If necessary, you can mount a hot stamp printer (not
available from Avery Dennison) onto the holder
brackets of the dispensing edge.
– Example of use: Printing consecutive numbers onto
labels.
Applicator
If it is not possible to label directly from the dispensing
edge, you can fit an applicator to the label dispenser.
Various types of applicators are available that depend
on the given requirements.
Simple applicators can be controlled directly via the
PLC signal interface [7G] that is available as standard.
Applicator interface
Additional board [7H]; allows almost all types of
applicators to be controlled.
Narrow label spring kit
Narrow label material may under certain circumstances
tear off or expand in a way which results in poor
labelling precision. In those cases, it is adviseable to
install weaker dancer arm springs.
[23] Capacitive label sensor with bracket and cable.
To Next Page
Loading...
