Avery Dennison ALS 256 - INSERTING LABEL MATERIAL; Inserting a label roll

41
3BEFORE OPERATION
3.2 INSERTING LABEL MATERIAL
ALS
20x
256
GB
3.2.1 Inserting a label roll
WARNING!
Risk of injury due to moving and rapidly
rotating parts!
 Before inserting the label roll, ensure that
the device is in offline mode.
Danger of injury caused by falling label roll!
 Wear safety shoes.
Removing spent backing paper
Assuming backing paper has gathered on the rewinder
[37A] :
 Press the release button [37B].
– The tensioning mechanism of the rewinder is
slackened.
 Remove the rewound backing paper.
Removing glue residue
 If necessary, clean the following components:
– Dispensing plate
– Deflection rollers
– Drive rollers
– Pressure roller
 Follow the directions provided in section
“Maintenance and cleaning” on page 56.
Inserting a new label roll
 Push the material roll [38A] onto the unwinder as far
as it will go.
 Rotate the rotary knob [38B] in a clockwise direction
until the label roll sits tightly.
 Run the label strip around the dancer arm as shown
in the figure [38C].
[37] A Rewound backing paper
B Release button
C Backing paper path
B
A
[38] Inserting the material roll – Part 1.
A
C
B
3.2 INSERTING LABEL MATERIAL