8
1PLEASE NOTE
1.2 SAFETY INSTRUCTIONS
ALS
20x
256
1.2.1 Information and qualifications
Qualification
Ensure the required qualifications are met
Ensure that only trained and authorized personnel
operate, configure and service the unit.
Only allow qualified and well-trained expert
personnel or service technicians to perform
configurations.
The responsibilities with regard to operation,
configuration and maintenance should be clearly
defined and consistently maintained.
In addition, personnel should also be instructed on
a regular basis in matters of occupational safety and
environmental protection.
Qualification for operation
The instruction of personnel using the unit must ensure
that:
– The operating personnel can use the unit on their
own and safely.
– The operating personnel can remedy small
operational disruptions on their own.
At least two people must be instructed in the unit’s
usage.
Enough label material must be provided for testing
and instructional purposes.
Qualification for system integrators and service
technicians („service personnel“)
Knowledge required to install the print
dispenser and perform service work must be
demonstrated through appropriate
qualification. Only service personnel with
technical training are able to assess the tasks to be
performed and recognise potential dangers.
– Knowledge acquired through technical training in
mechanics and electronics (for example in Germany
the training to become a mechatronics engineer).
– Participation in a technical training course for the
corresponding label dispenser offered by the
manufacturer.
– The service personnel must be acquainted with the
functionality of the label dispenser.
– The system integrator must be acquainted with the
functionality of the of the system into which the label
dispenser is being integrated.
1) For example faults when detecting labels
2) For example incorrect labelling
[1] An example of the distribution of tasks among different qualified
personnel
Tasks System integrator Operator Service technician
Install the machine X
Connect X
Make settings X
Switch on/off X X X
Insert/change material/ribbon X X X
Application-related settings X X X
Rectify minor operating faults
1
XX X
Clean the machine X X
Rectify major operating faults
2
X
Settings to the electronics/ mechanics X
Repairs X
Manual: Service manual Operating Manual Service manual, spare
parts catalogue
1.2 SAFETY INSTRUCTIONS
To Next Page
Loading...
