Avery Dennison ALS 256 - Threading the label roll onto the drive roller; Fastening the label roll to the rewinder

44
3BEFORE OPERATION
3.2 INSERTING LABEL MATERIAL
ALS
20x
256
GB
Threading the label roll onto the drive
roller
 Open the pressure roller. To do so, rotate the lever
[44D] in a clockwise direction.
 Feed the backing paper around the deflection roller
[44B], drive roller [44C] and the dancer arm [44A].
 Close the pressure roller. To do so, rotate the lever
until it snaps in noticeably.
Fastening the label roll to the rewinder
 Clamp the backing paper to the rewinder as shown
and tighten it [46].
If the machine is switched off:
 Manually rotate the rewinder by one turn.
If the machine is switched on:
 Make sure that the machine is in offline mode.
 Push the dancer arm [45A] against the top limit for
more than 2 seconds.
– The following error message shows up:
– Now, the rewinder can be turned manually.
 Turn the rewinder one turn.
 Press the key to acknowledge the error mes-
sage.
Status num: 5143
Rewinder stop
[44] Open the pressure roller.
[45] Close the pressure roller.
C
D
B
A
[46] Fastening the backing paper to the rewinder.