Avery Dennison Monarch 9825 - Page 4

LOADING RIBBON ....................................................................................... 3-1
Loading Ribbon....................................................................................... 3-2
SETTING SUPPLY OPTIONS......................................................................... 4-1
Setting the Supply Type........................................................................... 4-3
Setting the Ribbon .................................................................................. 4-4
Setting the Speed ................................................................................... 4-5
Setting the Feed Mode ............................................................................ 4-6
Changing the Position Settings................................................................. 4-7
Setting the Print Position...................................................................... 4-7
Setting the Supply Position................................................................... 4-9
Setting the Margin Position................................................................. 4-10
Setting the Dispense Position ............................................................. 4-11
Setting the Backfeed Distance ............................................................ 4-11
Using Batch Separators ......................................................................... 4-13
Using Skip Index................................................................................... 4-14
Setting the Print Contrast ...................................................................... 4-15
SETTING COMMUNICATIONS ....................................................................... 5-1
Setting the Baud Rate ............................................................................. 5-2
Setting the Word Length .......................................................................... 5-2
Setting the Stop Bits ............................................................................... 5-3
Setting the Parity .................................................................................... 5-3
Setting the Flow Control .......................................................................... 5-4
Resetting to Default Values...................................................................... 5-4
Using Parallel Communications ................................................................ 5-5
Setting the Port ................................................................................... 5-5
Setting the Mode ................................................................................. 5-6
ii Operator's Handbook