To change the setting, from the Main Menu, select Setup, Supply, then
Positioning. Then, follow these steps.
1. Press » or ¼ until you see
POSITIONING
» Print Pos ¼
2. Press Enter/Pause. The current setting is displayed, for example:
Enter print pos
[-99/99]: +0
3. Press » or ¼ to change the print position. Pressing » decreases the
value (moves the image down); ¼ increases it (moves the image up).
4. Press Enter/Pause when the number you need appears. Press
Escape/Clear until you see the Main Menu.
4-8 Operator's Handbook
To Next Page
Loading...
