ADVANCED MENU
~23~
7. ADVANCED MENU
Note: The following menu display takes 16CH DVR as an example, and some display may differ from the
actual display when users are using a 8CH or 4CH DVR.
Press “MENU” and enter the password to go to the quick-start menu list. Then, move to “ADVANCE” to enter the
advanced setting menu. The default admin password is 0000. Users can change the password later. Please refer to
“7.2 System Info” at page 31.
It is recommended that consult your installer to setup this advanced menu.
7.1 Advanced Configuration
In this menu list, you can check or change CAMERA / DETECTION / ALERT / NETWORK / SNTP / DISPLAY /
RECORD / REMOTE settings.
Move to “ ”, and you will see the following screen:
ADVANCE CONFIG
CAMERA
DETECTION
ALERT
NETWORK
SNTP
DISPLAY
RECORD
REMOTE
PLEASE CONSULT YOUR INSTALLER FOR ADVANCE SETTING
uv SELECT s BACK t NEXT ENTER
7.1.1 Camera
In this submenu, you can make advanced camera settings, such as changing the camera title, or adjust the
brightness. Move to “CAMERA”, and press “ENTER”. You will see the following screen:
CAMERA
TITLE BRIG CONT SATU HUE COV. REC
CH1 128 098 128 128 OFF ON
CH2 128 098 128 128 OFF ON
CH3 128 098 128 128 OFF ON
CH4 128 098 128 128 OFF ON
CH5 128 098 128 128 OFF ON
CH6 128 098 128 128 OFF ON
CH7 128 098 128 128 OFF ON
CH8 128 098 128 128 OFF ON
CH9 128 098 128 128 OFF ON
CH10 128 098 128 128 OFF ON
NEXT
PLEASE CONSULT YOUR INSTALLER FOR ADVANCE SETTING
uv SELECT s BACK t NEXT ENTER
The submenu items are described below. While you changing the camera setting, you can preview the changing
on the screen.
To Next Page
Loading...
Need help?
General
