ADVANCED MENU
~24~
1) TITLE
You can change the default camera naming here. The default title is the channel number.
Move to the camera title you want to change, and press “ENTER” on the control panel of the DVR to access the
character selection screen. Assign a new name to the camera up to six characters (letters or symbols or
numbers).
2) BRIG / CONT / SATU / HUE
You can adjust the brightness/contrast/saturation/hue of each channel here. The default value of CONT is 098,
and others are 128. The value is adjustable from 0 to 255.
3) COV
Select if you want to mask the selected channel under recording (ON / OFF). When this function is activated, the
wording “COV.” will be shown on the channel screen.
4) REC
Select if you want to enable recording for the selected channel (ON / OFF). When this function is activated, the
symbol “ ” will be shown on the channel screen.
7.1.2 Detection
In this submenu, you can set up detection-related functions.
Move to “DETECTION”, and press “ENTER”. The submenu items are described below:
1) TITLE
Show the camera title of each channel set in “CAMERA”.
2) DET
The available options vary depending on the model you have.
For Model 5 & 7: Select if you want to activate the motion detection function for the selected channel (ON/OFF).
For Model 1, 2, 3, 4, 6 & 8: Select HIGH / NORMAL / LOW to activate the motion detection function with different
sensitivity for the selected channel, or select OFF to disable this function.
3) AREA
Press “ENTER” to set the detection area. You will see similar screens as the following:
Pink blocks represent the area that is not being detected while the transparent blocks are the area under
detection.
There are two different methods to set the detection area depending on the model you have.
Model 1, 2, 3, 4, 6 & 8
Transparent blocks are the area under
detection.
Press “ENTER” to confirm the start area. Press / to choose the width of the
detection area.
Press / to choose the height of the
area.
You can also set up multi-detection area. When any movement is detected, you will
see the grids are flashing.
*Pink blocks represent the area that is not being detected while the transparent blocks are the area under detection.
To Next Page
Loading...
Need help?
General
