Axis SE-01 - Page 51

ENGINEERING DOCUMENTATION 51
_____________________________________________________________________________________________
11.Press → T ← key when "F..-4" is displayed.
The following options appear successively on display:
- „Auto” – automatic data transmission after scale indication is stable,
- „Recz” – manual data transmission by operator using key,
- „out” – exit.
12.Choose appropriate option pressing → T ← key.
13.Press → T ← key when "out" is displayed.
[Measurements]
14.Press MENU key.
15.When "F..-tP" is displayed press → T ← key. Select "F..-1".
16.Printout is performed.
17.Put successive good packages
1..1.1.1.1 Successive results will be printed in
table
with indication of their values using "*"
character referred to limit values.
18.After performing last measurement
"END" text will appear and summarising
report of control results will be printed:
PLACE OF
CONTROL:
.................................
Date: ... Time: ...
CONTROL NO.:
................................
SCALE TYPE : ...
FACTORY NO. :
...
BATCH SIZE : ...
VALUE Qn : ...
VALUE Qn-T1 : ...
VALUE Qn-2T1 :
...
Qn-2T1 Qn
Qn+2T1
... g *
... g *
...............