Badger Meter ModMAG M Series - Configuring Input;Output (I;O)

CONFIGURING INPUT/OUTPUT I/O
This section describes wiring the following M2000 meter inputs/outputs:
• Analog output
• Digital input
• Digital outputs
• Communication
Once the sensor and the transmitter have been wired, wire any inputs and outputs to the M2000 transmitter.
Do not connect the main power connection until you have made all other wiring connections. Follow all of the safety
precautions and local code to prevent electrical shock and damage to the electronic components.
I/O
Connections
AC DC
N
L
__
+
Communication Interface
Daughterboard
Supported protocols include: Modbus, HART, Profibus DP, M-Bus, BACnet MS/TP
Figure 21: Configuring input/output
Conguring Input/Output (I/O)
Page 22 March 2022MAG-UM-01272-EN-21