Setting Up the M2000 Meter with Quick Setup
The M2000 electromagnetic flow meter provides you with a Quick Setup utility that allows you to set or change your Flow
Units, Totalizer Units, Full Scale Flow and Low Flow Cutoff settings. To open the Quick Setup menu, select Quick Setup from
the Start Menu.
Quick Setup
Flow Unit
[Region]
Use Flow Unit to set the unit of measure for the flow rate and Full Scale Flow.
To change the Flow Unit value, follow these steps from the Quick Setup menu.
1. Select Flow Unit to view the Flow Unit display.
2. Press [↑] or [↓] to position the arrow next to one of the following Flow Units:
Code Flow Unit Code Flow Unit
LPS Liters/Second GPM Gallons/Minute
LPM Liters/Minute GPH Gallons/Hour
LPH Liters/Hour MGD Mega Gallons/Day
M
3
S Cubic Meters/Second IGS UKG/Second
M
3
M Cubic Meters/Minute IGM UKG/Minute
M
3
H Cubic Meters/Hour IGH UKG/Hour
F
3
S Cubic Feet/Second MID MegaUKG/day
F
3
M Cubic Feet/Minute LbM Pounds/Minute
F
3
H Cubic Feet/Hour OPM Ounces/Minute
GPS Gallons/Second BPM Barrels/Minute
3. Press [E] to save the Flow Units setting.
Totalizer Unit
[Region]
Use Totalizer Unit to establish the units of measure for the totalizers.
To change the Totalizer Unit value, follow these steps from the Totalizer Unit display.
1. Press [↑] or [↓] to position the arrow next to one of the following Totalizer Units:
Code Totalizer Unit Code Totalizer Unit
L Liter UKG Imperial Gallon
HL Hectoliter MIG Mega Imperial Gallons
M
3
Cubic Meter Lb Pound
CFt Cubic Feet Oz Fluid Ounce
USG U.S. Gallon Aft Acre Feet
MG Mega Gallon BBL Barrel
2. Press [E] to save the Totalizer Units setting.
Programming the M2000 Meter
Page 32 March 2022MAG-UM-01272-EN-21
To Next Page
Loading...
