Entering Your Personal Identification Number (PIN)
If your system has been set up with PIN security, you need to enter a PIN to access programming functions. There are three
access levels, each with its own unique PIN: User, Service and Administration. Your system administrator can provide you with
the appropriate PIN.
OTE: N All PINs are factory set to 00000. If the system administrator has not set the PIN, pressing [E] from the Start Screen
opens the Main Menu.
If you forget or misplace your PIN, call BadgerMeter Customer Service to get a master password. When you call, have
the security code that appears in the upper right corner of the PIN Request display.
Follow these steps to enter your PIN in the M2000 meter:
1. At the Main Menu, press [E]. The PIN Request display opens.
PIN REQUEST 12345
Please enter
pin #: 00000
CHG:+,- NEXT:E
Security Code
Figure 36: PIN request
2. Press [+] to increment the numeral.
3. Press [E] to move the cursor to the next digit.
4. Repeat the steps to enter each of the ve digits to match your PIN.
5. Press [E]. If you entered a valid PIN, the Main Menu opens indicating your level of access.
If you entered the wrong PIN, the following displays:
MENU ACCESS
DENIED
Figure 37: Wrong PIN entered
• Press [E] to return to the PIN Request display.
• Repeat Steps 1 through 5.
OTE: N Be sure to log off when you have completed work with the meter. Otherwise, there is a five-minute delay between
your last activity and the time when the meter automatically logs you off.
Programming the M2000 Meter
Page 31 March 2022 MAG-UM-01272-EN-21
To Next Page
Loading...
