Inputs/Outputs
Flow
Simulation
[Off]
S
Flow Simulation provides output simulation based on a percentage of the Full Scale Flow. Simulation
does not accumulate the totalizers. The range of simulation includes –100…100% of the Full Scale Flow.
The Flow Simulation Parameter lets you set the range of simulation in 10% increments.
To change the Flow Simulation, follow these steps from the Inputs/Outputs menu:
1. Select Flow Simulation to view the Flow Simulation display.
2. Click [+] to increment the percentage by 10, or click [–] to decrement the percentage by 10.
3. Press [E] to save the displayed setting and return to the Inputs/Outputs menu.
This function remains active after exiting the menu. Set Q on “Deactivate.” If the simulation is active, the
message “STS simulation” is displayed in measuring mode.
Clear Totals
TN
S
The bidirectional net totalizer, when reset, clears both the forward and the reverse flow totalizers (T+ and
T–). It is reset within the menu manager or through remote communications. Clearing TN also clears the
associated rollover counter.
T+
S
The bidirectional forward flow totalizer is reset within the menu manager or through remote
communications. Clearing T+ also clears the associated rollover counter.
T–
T–
S
The bidirectional reverse flow totalizer is reset within the menu manager or through remote
communications. Clearing T– also clears the associated rollover counter.
PS
S
The batch totalizer is reset to the configured preset amount value. It is reset within the menu manager,
remote communications or through a properly configured digital input (function = batch reset).
Tpwroff
S
The totalizer accumulating meter time without external power is reset with the menu manager or through
remote communications.
T1
S
The unidirectional totalizer T1 is reset within the menu manager.
T2
S
The unidirectional totalizer T2 is reset within the menu manager or with digital input.
VW
S
The preset batch is reset within the menu manager or with digital input.
Using the Main Menu Programming Options
Page 45 March 2022 MAG-UM-01272-EN-21
To Next Page
Loading...
