• Use the sling-rigged method to lift large sensors into a vertical position while they are still crated. Use this method to
position large sensors vertically into pipelines.
Figure 3: Sling-Rigged lifting methods
• Do not lift a sensor with a forklift by positioning the sensor body on the forks, with the flanges extending beyond the lift.
This could dent the housing or damage the internal coil assemblies.
• Never place forklift forks, rigging chains, straps, slings, hooks or other lifting devices inside or through the sensor's flow
tube to hoist the unit. This could damage the isolating liner.
Do not lift sensor with forklift Do not lift or rig lifting devices through sensor
Figure 4: Lifting and rigging cautions
Unpacking and Inspection
Page 8 March 2022MAG-UM-01272-EN-21
To Next Page
Loading...
