Need help?Do you have a question about the Balluff BNI ECT-507-005-Z040 and is the answer not in the manual?
General| Brand | Balluff |
|---|---|
| Model | BNI ECT-507-005-Z040 |
| Category | Control Unit |
| Language | English |
Explains formatting used for actions, syntax, enumerations, and cross-references.
Defines the module's intended application and restrictions.
Provides caution for installation by trained personnel and proper use.
Outlines safety obligations and precautions for operators.
Advises on chemical resistance and material checking.
Warns to switch off power before working on the device.
Presents a visual overview of the BNI ECT module with labeled components.
Details how the module is secured using M6 screws and washers.
Describes electrical connections, including power supply, grounding, and interfaces.
Details pin assignments for power supply and sensor/actuator connections.
Emphasizes low impedance functional ground connection.
Describes M12, D-coded female connector for EtherCAT communication.
Details M12, A-coded female connector for IO-Link ports.
Explains communication between the module and the controlling system via EtherCAT.
Explains module representation and data availability in project planning software.
Guides on integrating the device into planning software like TwinCAT.
Explains pre-configuration of IO-Link ports and outputs during startup.
Guides on reading/writing IO-Link ISDU parameters via object 0x4000.
To Next Page
