This dialog is used for displaying the internal module diagnostics capabilities and shows
events as they have occurred over time. A tool for detailed troubleshooting in equipment is
provided.
Events are classified using the "Severity“ column as follows:
1) Internal error: The fieldbus module has detected a fault in itself (hardware or
software) which should not occur during normal operation. If this happens, the
module must be serviced or replaced. These errors are classified as "Emergency“,
"Alert“ or "Critical“.
2) External error: The fieldbus module has detected what may be a non-permissible
event which is affecting the module from the outside. The system may require
troubleshooting. This error is classified as "Error“ or "Warning“.
3) Event: The fieldbus module has detected an important normal operating event and
reports it. These may include also configuration actions over the web interface and
other configuration interfaces which are also recorded. These messages are
classified as "Notice“.
Pressing "Set Module Time“ sends the current browser time to the fieldbus module.
Pressing "Update Log" updates the display.
To Next Page
Loading...
Need help?
General
