The configuration page permits configuration of the module. You can change the displayed
module information texts and module parameters.
The "Set Ports" action is not permanently stored in the device and is lost after the next reboot.
The parameter set “Module Configuration” on the left side is used by pressing "Save
Configuration" and permanently stored in the device.
The "Reboot" button restarts the device like after power has been turned off and on again.
Pressing "Factory Reset" deletes the configuration stored in the device, all uploaded IODD
files as well as saved log files and then performs a reboot, so that the device is again in the
default factory configuration.
To Next Page
Loading...
Need help?
General
