Figure 106. iVu Plus BCR—PLC Input Assembly (102), PLC Output Assembly (113)
Figure 107. Select or clear the Unicast Connection checkbox as desired
Note: The minimum allowed RPI is 50 ms.
3. If the module configuration was successful, the following information displays:
Figure 108. Successful Configuration
If the module configuration was not successful, the RSLogix 5000 software will indicate errors similar to the
following
figures:
iVu Plus BCR Gen2 Series Sensor
www.bannerengineering.com - Tel: + 1 888 373 6767 115
To Next Page
Loading...
