Banner iVu Plus BCR Gen2 Series - System Configuration Menu; Save to USB; Load from USB; Reset to Defaults

Note: Switch between Live Mode and Demo Mode any time by going to Main Menu > System > Mode.
11.2 System Configuration Menu
Main Menu > System > Configuration
The Configuration screen allows users to save configurations, load new configurations, or reset the device to default values.
The
configuration options are:
• Save to USB—Save the device configuration to a USB flash drive
• Load from USB—Load the device configuration from the USB flash drive
• Reset to Defaults—Reset the device configuration to defaults
Figure 36. Configuration Menu
11.2.1 Save to USB
Main Menu > System > Configuration > Save to USB
The Save to USB screen allows the device configuration to be saved to a USB flash drive. The saved configuration
information can be used as a backup or to clone configuration information for other devices.
Note: On the Emulator, this option is Save
Configuration.
11.2.2 Load from USB
Main Menu > System > Configuration > Load from USB
The Load from USB screen allows the device configuration to be restored from a USB flash drive. This operation removes
all existing inspections and replaces them with inspections contained in the configuration file on the USB flash drive.
Note: On the Emulator, this option is Load
Configuration.
11.2.3 Reset to Defaults
Main Menu > System > Configuration > Reset to Defaults
Resets the device to factory default state:
• All existing inspections are deleted
• All imager and system settings are reset to factory defaults
• Device-specific information such as the sensor name and Ethernet settings are not changed
• System Log information is retained
The device reboots after this operation is complete.
iVu Plus BCR Gen2 Series Sensor
54 www.bannerengineering.com - Tel: + 1 888 373 6767