Banner iVu Plus BCR Gen2 Series - 5 Vision Manager; Connect to the Sensor

5 Vision Manager
Connect to the iVu BCR using Vision Manager PC Software to control the device remotely. After connecting to the device,
the interface displays on the Sensor tab. Use the interface in the same manner as the iVu BCR display.
Vision Manager is not required to configure or run the iVu BCR.
5.1 Connect to the Sensor
These instructions use Windows
®
operating system version 7, 8, or 10.
7
1. Confirm the network connections.
a) Click the Start button, then on the Start menu, click Control Panel.
b) In Control Panel, click Network and Internet, then click Network and Sharing Center, and then click Change
adapter settings.
c) Right-click on the connection that you want to change, then click Properties.
If you are prompted for an administrator password or
confirmation, enter the password or provide confirmation.
d) In the connection properties, click Internet Protocol Version 4 (TCP/IPv4), and then click Properties.
Figure 11. Local Area Connection Properties
e) In the Internet Protocol (TCP/IPv4) Properties, select Use the following IP address.
f) Make sure that the IP address is 192.168.0.2, and the subnet mask is 255.255.255.0.
2. Open Vision Manager from the desktop or the Start menu.
The Sensor Neighborhood tab displays and lists the available sensors.
3.
From Sensor Neighborhood, click to connect to the desired sensor.
The status changes from Available
to Connected and the Sensor screen displays. Click to disconnect
from the sensor.
4. If the desired sensor is not listed, verify that:
• The network adapter connected to the sensor has the same subnet mask as the sensor (for example,
192.168.0.xxx); view the subnet mask in the Network Adapters list at Home > Sensor Neighborhood >
Network Adapters
• The Ethernet cable is the correct type
• The TCP/IPv4 settings are correct
Or, manually enter the sensor's IP address.
Note: The sensor's IP address and subnet mask are also available from the sensor display.
7
Windows is a registered trademark of Microsoft Corporation in the United States and/or other countries.
iVu Plus BCR Gen2 Series Sensor
22 www.bannerengineering.com - Tel: + 1 888 373 6767