Pin # Wire Color Description Direction
5 Gray Remote Teach Input
6 Pink External Trigger Input
7 Blue Common (Signal Ground) Input
8 Red Ready Output
9 Orange Output 3 Output
10 Light Blue RS-232 TX Output
11 Black RS-232 Signal Ground Output
12 Violet RS-232 Rx Input
4.3 Installing a Filter on an iVu BCR
Installing a Filter on the Micro Video Lens Model
To install a
filter on the iVu BCR with Micro Video Lens, use the illustration as a guide and follow the steps listed below.
CAUTION: Failure to follow these instructions may cause damage to your iVu BCR.
CAUTION: Electrostatic Discharge
Avoid the damage that electrostatic discharge (ESD) can cause to the Sensor.
Always use a proven method for preventing electrostatic discharge when installing a lens or attaching a
cable.
A Lens
B Focusing Window
C Locking Clip
D Locking Screw
E Filter Cap
F Filter
Figure 8. Micro Video Lens Model Components
Note: Filter kits are available separately.
1. Remove the locking screw (D) using the 1/16-inch hex key.
Note: The locking clip (C) inserts in a groove near the top of the focusing window (B). When
removing the window, the locking clip will be loose. Do not to lose the clip while removing the
window.
2. Unscrew the focusing window by turning it clockwise approximately 5 complete turns or until the focusing window
disengages from the light/lens assembly.
iVu Plus BCR Gen2 Series Sensor
www.bannerengineering.com - Tel: + 1 888 373 6767 19
To Next Page
Loading...
