Figure 129. Hardware Catalog
The system installs the iVu BCR GSD file and places it in the Hardware catalog. In the above example, the iVu BCR
GSD file is located under Other field devices > PROFINET IO > Sensors > Banner Engineering Corp. > Banner Vision
Sensors > iVu Series .
Note: If the iVu BCR GSD file does not install properly, save the log and contact Banner
Engineering Corp.
Adding a Device to a Project
Use these instructions to add a iVu BCR device to a Siemens TIA Portal (v13) project, and to configure the device. Use
these instructions as a basis for adding a iVu BCR device to another controller (PLC).
1. Start the Siemens TIA Portal (v13) software.
2. Click Open existing project.
3. Select a project and open it.
iVu Plus BCR Gen2 Series Sensor
www.bannerengineering.com - Tel: + 1 888 373 6767 147
To Next Page
Loading...
