Banner iVu Plus BCR Gen2 Series - Page 161

Figure 163. Edit Ethernet Note Screen
The Edit Ethernet Node window is updated.
9. Set the IP address to the desired value.
10. Click Assign IP
Configuration at the bottom left of the Set IP configuration section.
The parameters are transferred.
11. Click OK to acknowledge the message of a successful transfer.
Figure 164. Edit Ethernet Node Message
The IP address adjustment is complete.
Changing the Device Name
Use these instructions for the Siemens SIMATIC STEP 7 (v5.5) software.
1. Start Siemens SIMATIC Manager.
2. Select an existing project and open it.
3. Select a Station (PLC) from the Object Hierarchy list.
iVu Plus BCR Gen2 Series Sensor
www.bannerengineering.com - Tel: + 1 888 373 6767 161