3. Physical Installation
Mains power requirement
Projector Power Requirement
Balder 100 –240V. 50 –60 Hz.
To protect opera ting personnel, the National Electrical Manufacturers A ssociation (NEM A) rec omm ends that the instrument panel
and cabinet be grounded.
In no event sh all this projector be operated without an adequate cabinet ground connection.
The AC supply must be installed by a qua lified e lectrician in co nformance to local codes. Hardware, wire sizes and conduit types
must comply with local codes.
Ventilation
The free space necessary between the air intake and exhaust are shown below.
1000 mm
500 mm
Image 3-1
3.3 Initial inspection
General
Each project or is inspected and rigorously tested at our production facility to ens ure that it is free from any mechan ical or electrical
defects.
Upon receipt of the projector, we recommend that custom ers inspect the pr ojector for any signs of damage that may have occurred
in transit. If damage is found, file a claim with the shipping carrier immediately. Notify the Barc o Sales and Service office, or your
preferred B arco agent, of the damage as soo n as pos sible.
Box Contents
Your projector box should contain the following:
• Projector unit
• Power cord (suitable for reg ion)
• Quick start guide
• Safety manual
• Remote Control
20
601–0442 BALDER 13/09/2017
To Next Page
Loading...
