7. Installation menu
Image 7-7
Installation menu, Warp
2. In the Warp menu, select Bo w .
Image 7-8
Warp menu, Bow
A check sy mbol at the bottom right co rner indicates that the bow function is activated.
3. To enable Bow correction, make sure the Bow slider is set to On.
The slider is enabled when set to the right and when it is colored blue.
Image 7-9
Bow adjustment
4. To enable a symm etric adjustment, m ake sure the Symmetric slider is set to On.
The slider is enabled when set to the right an d wh
en it is colored blue.
5. Select an adjustment point and us e the arrow key s to adjust.
When selecting a mid point of an edge, the bow angle can be adjusted.
When selecting a corner point, the linearity c an be adjusted.
To reset the bow adjustme nts, select Reset and press the OK b utton.
7.5 Basic Blend
About
When two projectors are used together to mak e one picture o n t he s creen, the blend function must be activated. T his blend function
ensures a seam less transition of the images between the two projectors.
The pr inciple is that the light intens
ity in the blend zone from each projector will be adjusted individually, so that the rendering on the
screen are perceived as from one projector.
The b lend function can be enabled for both pictures over/under, and pictures side by s ide.
601–0442 BALDER 13/09/2017
45
To Next Page
Loading...
