Barco Balder - Source and Control Connections

4. Getting started
4. GETTING STARTED
About this chapter
This chapter describes how to set up and optimize your projector setup w hen the physical installation p rocess is complete.
Overview
• Pr ojector source and control connections
• Power up the projector
• Power down the p rojector
• Power modes
• C ustomize projector settings
• U ser interface
4.1 Projector source and control connections
Overview
• Making connections
• C onnector specifications
• C ontrol interfaces
4.1.1 Making connections
The source switching time varies from 0.5 to 5 seconds.
Source signal connectivity
The connector panel at the back of the projector is used for all source connections.
Source signal connectivity on the projector is:
• 2 x Dual Link DVI-I (DVI-D functionality)
• 2x DisplayPort 1.2
• 1x HDMI 2.0
• 1x HDB aseT
•1x3GSDI
4.1.2 Connector specifications
Overview
•DVI-I
• Display Port 1.2
• HDM I 2.0
•3G-SDI
• HDB ase T
4.1.2.1 DVI-I
Specifi ca tions
Param eter Value
Connector DVI-I fem ale digital RGB
Signal characteristics DVI 1.0, Digital, TMDS
Max. cable length 25 m ( 24 AWG)
601–0442 BALDER 13/09/2017 29