6. Advanced picture adjustments
Image 6-1
Enter the menu showe above,and select the input format from the dropdown menu.
Exit the menu.
6.3 Manual Cropping
Image 6-2
When the preset values do not match the input format, the m anual mode must be used
Enter the m enu, and select man ual. The OSD w ill show four numeric values that may be changed, and each num eric value indicates
the number of black display lines that shall be removed.
Select the “top” value, and enter a su itable numeric va lue. If necessary, do several iterations in order to match the c orrect value.
Select the “bottom” valu
e, and enter the same value as for the “top”.
Then the left and right sides m ust be adjusted. The value entered here m u st be equal to the vertical lines removed, multiplied with
the aspect ratio, in order to kee p the correct correlation between the width and height
. Example: r emov ed 200 lines in 16:9 format: 200 x (16/9) = number of lines to rem ove on ea ch side.
38
601–0442 BALDER 13/09/2017
To Next Page
Loading...
