5. Image menu
Select how to adjust the white point. There are two alternatives: temper ature and c oordinate.
Temperature
The white point is specified on a Kelvin scale between 3200K – 13000K tracking along the black body curve.
Coordinate Coordinate: The w hite point is specified using an x,y coordinate in the CIE 1931 Chart.
Color mode
Image / Advanc ed / P7 RealColor — >Color Mode
Used to set the coordinates for color processing m ode: RG B, RGB CMY, White.
RGB Red, Green and B lue are moved according to the specified desired coordinates. Cya n, M agenta and Yellow
are calculated accordingly.
RGBCMY Red, Green, Blue, Cyan, Magenta and Yellow are moved according to the specified des ired coordinates.
White
White point only. N o cha nges to RGBCM Y. Default: W hite
Native
Native Colors. (Color Correction Off).
Native values
System Setting/ Service / Color —>Measured values
The current m easured values (WRG B ) used for RealColor processing.
These values must be accurate for RealColor to perform correctly.
Current values are presented in the color gamu t d iagram. Measured values are r epresented b y a solid line.
Default: values measured at the manufacturers facility.
Custom values
Image / Adv anced / P7 RealColor —>Mode
Allows users to specifying red, green blue, cyan, m agenta and yellow color coordinates (x,y) and gain.
Current values are presented in the color gam ut diagram. Desired v alues are represented by a dotted line.
36
601–0442 BALDER 13/09/2017
To Next Page
Loading...
