3. Physical Installation
Apply a Scheimpflug correction
1. Loosen the three set screws (reference 1b, 2b, 3b). Use a size 6 h ex key to do this.
1b
2b
3b
Image 3-6
2. Adjust the left side Sche impflug adjustm ent screw (reference 1) until the test image in the top right side of the screen is in focus.
Useasize4hexkeytodothis.
Note: This process may ca use the o ther areas of the image to slide ou t o f focus . This is totally normal.
1
F
Image 3-7
3. Adjust the right s ide Scheim pflug adjustment screw (reference 2) until the test image in the top left side of the screen is in focus.
Useasize4hexkeytodothis.
Note: This process may ca use the o ther areas of the image to slide ou t o f focus . This is totally normal.
2
F
Image 3-8
4. Adjust the top Scheimpflug adjustment screw (reference 3) u ntil the test image in the bottom half of the screen is in focus. Use
asize4hexkeytodothis.
Note: This process may ca use the o ther areas of the image to slide ou t o f focus . This is totally normal.
3
F
Image 3-9
5. Continue adjus ting the screws one at a time until the test image is uniformly sharp across all areas of the display.
26
601–0442 BALDER 13/09/2017
To Next Page
Loading...
