Barco ClickShare CB Core Installation Manual

R5917517 /00 ClickShare CB Core, CB Pro30
• For CB Pro:
1
2
Image 4–17 Where to connect the USB-C cable or dongle and the USB-A cable (only for touch screens)
1 USB-C cable or USB-C to HDMI dongle
2 Touch screen USB-A cable
Note: It is possible to use this connection to both charge the Base Unit and display image on the
connected screen.
When the display is correctly configured, the ClickShare setup splash screen will be displayed on the
monitor.
3. Is the display a touch screen? (only supported by CB Pro)
► Yes and the touch functionality is supported via the “USB-C” connection.
► Yes and the touch functionality is not supported via the “USB-C” connection, connect a “USB-A” cable
to the “USB-A” port of the Base Unit. (reference 2)
► No, go to next step.
4. Route the cable(s) through the cable binder. (optional)
5. Close the cable cover at the back of the Base Unit when no further connections must be made.
4.3.3 Connecting over LAN
About LAN connection
Connecting the CB Core, CB Pro to the LAN, allows for the configuration and management of the Base Unit
remotely.
How to connect
1. Remove the cable cover at the back of the Base Unit.
Image 4–18 Cable cover removal
2. Connect an “ethernet” cable from the LAN to the “ethernet” port at the back of the Base Unit. (reference 1)
• For CB Core:
Installing CB Core, CB Pro

Barco ClickShare CB Core Specifications

General

Brand	Barco
Model	ClickShare CB Core
Category	DVD Player
Language	English