Barco Coronis 5MP - Page 100

System manual Coronis 5MP 101
Figure 83
25. When the CORONIS Rotation Service InstallShield Wizard has
finished installing the software, it will tell you that it has finished
installing the software on your computer and prompt you to click
“Finish”“Finish”
“Finish”“Finish”
“Finish” to complete the setup (figure 84).
Click “Finish” Click “Finish”
Click “Finish” Click “Finish”
Click “Finish” to exit
the CORONIS Rotation Service InstallShield Wizard and to return
to the BarcoMed Product Installation Wizard.
Figure 84
Click
“Finish”“Finish”
“Finish”“Finish”
“Finish” to exit the BarcoMed Product Installation Wizard
(figure 85) or click
“Back”“Back”
“Back”“Back”
“Back” if you wish to install additional
BarcoMed software.
BarcoMed software driver installation