System manual Coronis 5MP 81
Setting the Resolution of Your 5MP CORONIS Display PanelSetting the Resolution of Your 5MP CORONIS Display Panel
Setting the Resolution of Your 5MP CORONIS Display PanelSetting the Resolution of Your 5MP CORONIS Display Panel
Setting the Resolution of Your 5MP CORONIS Display Panel
with DualView Disabledwith DualView Disabled
with DualView Disabledwith DualView Disabled
with DualView Disabled
1. To set the resolution for your CORONIS display panel(s), right click
on the desktop and select
“Properties”“Properties”
“Properties”“Properties”
“Properties”. Select the
“Settings”“Settings”
“Settings”“Settings”
“Settings”
tab (see Figure 57). Now select the
rectrect
rectrect
rect
angleangle
angleangle
angle that represents the
BarcoMed Display Controller you are working with.
SPECIALSPECIAL
SPECIALSPECIAL
SPECIAL
NOTE: NOTE:
NOTE: NOTE:
NOTE: If you are using the VGA capabilities of your
BarcoMed Display Controller, the resolution for that controller will
still be set to a VGA resolution of “640 x 480” pixels. If the
BarcoMed Display Controller is not running VGA, the device may
not be enabled yet. To enable the device
checkcheck
checkcheck
check the “Extend my
Windows desktop onto this monitor” checkbox. Do not click the
“Apply”“Apply”
“Apply”“Apply”
“Apply” button at this time.
2. Click on the
“Advanced”“Advanced”
“Advanced”“Advanced”
“Advanced” Button.
Figure 57: The Windows 2000 Display Properties Control Panel Settings Tab
after the drivers have been installed and the resolution set.
Note: Note:
Note: Note:
Note: The system shown in figure 57 above is a single BarcoMed
Display Controller, no 3
rd
party VGA card configuration, your system
may look different.
3. Select the
“Adapter”“Adapter”
“Adapter”“Adapter”
“Adapter” tab and then click on the
“List “List
“List “List
“List
All Modes…”All Modes…”
All Modes…”All Modes…”
All Modes…”
button. Select the desired resolution and refresh rate that your
BarcoMed software driver installation
To Next Page
Loading...
