Barco Coronis 5MP - Reinstalling the Barcomed Driver; Setting the Resolution of Your CORONIS Display Panel

System manual Coronis 5MP 60
Reinstalling the BarcoMed DriverReinstalling the BarcoMed Driver
Reinstalling the BarcoMed DriverReinstalling the BarcoMed Driver
Reinstalling the BarcoMed Driver
To reinstall only the BarcoMed Driver, follow the steps described in the
section
“Using the BarcoMed Product Inst“Using the BarcoMed Product Inst
“Using the BarcoMed Product Inst“Using the BarcoMed Product Inst
“Using the BarcoMed Product Inst
allation Wallation W
allation Wallation W
allation W
izard”izard”
izard”izard”
izard” with the
following changes.
1. Skip Step 1.
2. In Step 4, clear the checkboxes next to the BARCO DPMS and the
CORONIS Rotation Service.
3. When the driver has finished installing, click
“Finish”“Finish”
“Finish”“Finish”
“Finish”. Then click
“Quit”“Quit”
“Quit”“Quit”
“Quit”. Reboot the system when prompted and then reset the
resolution of your displays if necessary.
Setting the Resolution of Your CORONIS Display PanelSetting the Resolution of Your CORONIS Display Panel
Setting the Resolution of Your CORONIS Display PanelSetting the Resolution of Your CORONIS Display Panel
Setting the Resolution of Your CORONIS Display Panel
After you have logged in using an account with administrator
privileges per step 19 above, Windows NT will launch the
“Invalid“Invalid
“Invalid“Invalid
“Invalid
Display Settings”Display Settings”
Display Settings”Display Settings”
Display Settings” dialog box with the following message:
“ A new graphics driver has been installed. The default
display resolution from the driver has been temporarily used
by the system. Please use the Display option in the
Windows NT Control Panel to select your preferred display
resolution.”
1. Click
“OK”“OK”
“OK”“OK”
“OK”.
2. Windows will launch the
“Display Properties Contol Panel”“Display Properties Contol Panel”
“Display Properties Contol Panel”“Display Properties Contol Panel”
“Display Properties Contol Panel”.
Click on the
“Settings”“Settings”
“Settings”“Settings”
“Settings” tab and click on the
“List all Modes“List all Modes
“List all Modes“List all Modes
“List all Modes”
button (figure 27).
BarcoMed software driver installation