Barco Coronis 5MP - Barcomed Driver Tab; Introduction

System manual Coronis 5MP 109
BARCOMED DRIVER TABBARCOMED DRIVER TAB
BARCOMED DRIVER TABBARCOMED DRIVER TAB
BARCOMED DRIVER TAB
IntroductionIntroduction
IntroductionIntroduction
Introduction
After the BarcoMed Windows Display Controller Driver is installed, a
new Display Properties tab is available for configuring special features
of the BarcoMed Display Controller. Please note that you must have
logged on to Windows using an account with administrator privileges
in order to use the BarcoMed Control Panel to change any display
settings.
1) Open the “Display Properties Control Panel” by right clicking on the
desktop, then select “Properties”..
2) Under Windows NT 4.0, Click on the “BarcoMed Driver” Tab. (see
figure 91, below).
Under Windows 2000, click on “Settings” tab. Double click on the
rectangle that represents the BarcoMed Display Controller to bring
up its property page. Click on the “BarcoMed Driver” tab
(see figure 92, on the next page).
Under Windows XP, click on “Settings” tab. Double click on the
rectangle that represents the BarcoMed Display Controller to bring
up its property page. Click on the “BarcoMed Driver” tab
(see figure 93, on the next page).
Figure 91: BarcoMed Driver Tab under Windows NT 4.0
BarcoMed software driver installation