Barco Coronis 5MP - Re-Enabling Dualview under Windows XP

System manual Coronis 5MP 107
Re-enabling DualView under Windows XPRe-enabling DualView under Windows XP
Re-enabling DualView under Windows XPRe-enabling DualView under Windows XP
Re-enabling DualView under Windows XP
If you have disabled DualView using the method described on the
previous page and decide you want to re-enable it. Re-enabling
DualView on one BarcoMed controller will re-enable it on all the
BarcoMed controllers installed in your system. Following the steps
listed below.
1. Open the “Display Properties Control Panel” by right clicking on the
desktop, then select
“Properties”“Properties”
“Properties”“Properties”
“Properties”.
2. Click on
“Settings”“Settings”
“Settings”“Settings”
“Settings” tab. Double click on the rectangle that
represents the BarcoMed Display Controller you are working with
to bring up its property page. Click on the
“BarcoMed Driver”“BarcoMed Driver”
“BarcoMed Driver”“BarcoMed Driver”
“BarcoMed Driver” tab.
3. Select
“Enable DualV“Enable DualV
“Enable DualV“Enable DualV
“Enable DualV
iew”iew”
iew”iew”
iew” from the “Monitor Configuration” drop
down menu (see figure 90 below). Click
“OK”“OK”
“OK”“OK”
“OK”, twice. Your system
will automatically shutdown and restart.
Figure 90: BarcoMed Driver Tab – Enabling DualView
4. When your machine comes back up, you will need to re-set up
your CORONIS displays with the desired display settings.
BarcoMed software driver installation