System manual Coronis 5MP 63
InstInst
InstInst
Inst
alling the BarcoMed 5MP2F Walling the BarcoMed 5MP2F W
alling the BarcoMed 5MP2F Walling the BarcoMed 5MP2F W
alling the BarcoMed 5MP2F W
indows 2000indows 2000
indows 2000indows 2000
indows 2000
SofSof
SofSof
Sof
twaretware
twaretware
tware
Using the BarcoMed Product Installation WizardUsing the BarcoMed Product Installation Wizard
Using the BarcoMed Product Installation WizardUsing the BarcoMed Product Installation Wizard
Using the BarcoMed Product Installation Wizard
SPECIALSPECIAL
SPECIALSPECIAL
SPECIAL
NOTE: NOTE:
NOTE: NOTE:
NOTE: Prior to installing the BarcoMed drivers and related
software you MUST install the BarcoMed Display Controller(s),
connect the CORONIS display panel(s) to the card(s), and turn the
CORONIS display panel(s) on. Refer to the Hardware Installation
section of this manual for instructions on installing the BarcoMed
Display Controller(s) and connecting them to the CORONIS display
panel(s).
The following software installation instructions presume that Windows
2000 is already installed on your system. If you need to install or
reinstall Windows 2000 on your system you must first remove the
BarcoMed Display Controller(s) and use a 3
rd
party VGA card and
VGA monitor during the Windows 2000 installation process.
To install your BarcoMed 5MP2F Windows Display Controller Driver,
BARCO DPMS Screen Saver and CORONIS Rotation Service for the
first time follow the steps below. If you are reinstalling the drivers or
installing a new driver release over an existing driver release skip to
the step 5 on the next page:
1. Install the BarcoMed Display Controller(s) into your machine.
Please refer to the hardware installation section of this manual for
more information.
2. Boot the machine, and log in using an account with administrator
privileges.
3. For each BarcoMed Display Controller you have installed,
Windows 2000 will automatically launch the “Found New Hardware
Wizard” (see figure 28 on the next page). Click
“Cancel”“Cancel”
“Cancel”“Cancel”
“Cancel” to exit
the “Found New Hardware Wizard”. Continue to click
“Cancel”“Cancel”
“Cancel”“Cancel”
“Cancel”
until Windows 2000 stops launching the “Found New Hardware
Wizard - Video Controller”.
BarcoMed software driver installation
To Next Page
Loading...
