Barco Coronis 5MP - Precautions; Before Installing the Display

To Next Page

To Previous Page

System manual Coronis 5MP 27

INSTINST

INST

ALLAALLA

ALLA

TIONTION

TION

PrecautionsPrecautions

Precautions

• Keep your original packaging. It is designed for this display and is

the ideal protection during transport.

• Avoid reflections in the flat panel to reduce eye strain.

• Place the display on a strong and stable table or desk.

• Keep the display away from heat sources and provide enough

ventilation in case it is built in a rack or console.

• Make sure all equipment is switched off before connecting the

signals.

Before instBefore inst

Before inst

alling the displayalling the display

alling the display

ImportImport

Import

ant:ant:

ant:

In the factory, the height-positioning system in the display foot is

blocked with a strap to prevent damage during transportation.

Before installing the display, you must remove this strap.

o remove the strap:o remove the strap:

o remove the strap:

1 Position the display with its rear side facing you.

2 If the foot cover is mounted on the foot, lift up the 2 clips of the foot

cover to release the cover from the foot.

3 Pull the lower side of the cover towards you and simultaneously

slide the cover downward.

4 Pull the red strap out of the fixation holes in the foot.

You can better leave the cover off the foot while connecting the signal

cables to the display.

Display installation

Other manuals for Barco Coronis 5MP