Barco Coronis 5MP - Monitor Settings; Use as Logon Screen Saver; Getting Started with the BARCO DPMS Screen Saver

System manual Coronis 5MP 128
etatSSMPD sgnivaSrewoP
rotinoM
emiTyrevoceR
nOenoNA/N
yb-dnatSlaminiMtrohS
dnepsuSlaitnatsbuSregnoL
ffOmumixaMtsegnoL
Monitor SettingsMonitor Settings
Monitor SettingsMonitor Settings
Monitor Settings
Select the amount of time the display requires to warm-up. Since all
CRT based displays require some warm-up time before they are at full
performance, this ensures that the display is ready for use at the
beginning of the work day.
If you have a Barco Medical Display, select “Barco Quick Start.” If a
non-Barco display is being used, select the amount of time it takes
your display to warm up via the “Monitor Setting” section. Contact
your display vendor for this warm-up time.
On Barco CORONIS displays, the I-GUARD will stabilize the image
within a few seconds after the display returns to the active state so
there is no need for a warm-up time period.
Use As Logon Screen SaverUse As Logon Screen Saver
Use As Logon Screen SaverUse As Logon Screen Saver
Use As Logon Screen Saver
Check the box to use the BARCO DPMS Screen Saver when no one
is logged into the system.
Uncheck the box to use the default screen saver when no one is
logged into the system.
Getting stGetting st
Getting stGetting st
Getting st
arted with the BARCO DPMSarted with the BARCO DPMS
arted with the BARCO DPMSarted with the BARCO DPMS
arted with the BARCO DPMS
Screen SaverScreen Saver
Screen SaverScreen Saver
Screen Saver
The easiest way to get started is to select an existing settings scheme
and then modify it with your preferences. Settings schemes are
separated into two kinds, DEFAULT (global) and PRIVATE (personal).
Upon installation, three default settings schemes are installed and no
private settings schemes are installed.
Default settings schemes are visible to all users of the system.
However, they can be modified only by users with administrator
BarcoMed software driver installation